dickey seat step plate, an aluminium casting 130mm x 79mm with step tread top and curved under to fit on to the rear mudquard to act as a step when climbing into rear dickey seat. supplied undrilled etc only.
£15.25
|
petrol can carrier of a vintage pattern. strongly made from steel base clamp with cast end. screws to board, and supplied with slot key for bolt. black painted finish. size 218mm deep x 140mm wide.
£41.00
|
quality brass petrol can carrier copied from a 'Walker' original. the two gallon can is strapped over the top on to the running board. when not in use the arms of the carrier fold flat on to the running board. available in polished brass or nickel plate at extra cost.
£71.20
|
petrol can carrier for standard 1 or 2 gallon original cans - cast aluminium 'A' frame type with slot screw clamp, copied from a 'Prima' original. size 175mm x 190mm approx. frame screws on to running board, not polished.
£23.00
|
petrol can carrier for standard 1 or 2 gallon original cans - cast aluminium 'A' frame type with knurled grip screw clamp, copied from a 'Grippo' design. size 175mm x 190mm approx. frame screws on to running board, not polished.
£23.00
|
aluminium petrol can frame which screws to running board and totally surrounds the base of the can. smooth aluminium frame 294mm x 190mm into which can sits, to be retained with an internal clamp, supplied with slotted key.
£58.00
|
coconut hand made mat , approx 375mm x 225mm which is fitted with two brown leather straps long enough to fit a 300mm wide running board. no holes are required to fit this part on to vehicle.
£54.25
|
aluminium running board step plate with aluminium pyramid pattern tread insert. the aluminium frame is not polished. dimensions approx 315mm long, ends 131mm and 104mm (front edge of step tapers) with 48mm high rear upstand which can be cut off if required. offered in pairs only (1 left hand + 1 right hand).
£41.80
|
aluminium running board step plate with ribber rubber insert. the aluminium frame is not polished, but is drilled for mounting screws. the moulded step plate insert is black ribbed. dimensions approx 315mm long, ends 131mm and 104mm (front edge of step tapers) with 48mm high rear upstand which can be cut off if required. offered in pairs only (1 left hand + 1 right hand).
£66.30
|
