View Basket0 item(s) in the basket.
Orderline: +44 (0)1684 219864
£GBP
Prices in currencies other than GBP are for guidance only. The actual rate will be that used by the credit card company at the time of billing.
Prices in currencies other than GBP are for guidance only. The actual rate will be that used by the credit card company at the time of billing.
Min. Shipping :£0.00
VAT (20%): £0.00
Total: £0.00
Prices in currencies other than GBP are for guidance only. The actual rate will be that used by the credit card company at the time of billing.
Dickey seat step plate - a brass casting 130mm x 79mm with step tread top and curved under to fit on to the rear mudguard, to act as a step when climbing into rear dickey seat. Supplied undrilled, unpolished etc only. Weighs 900grams.
Fluted angle, nickel plated brass running board edging. Measures 18mm across by 18 mm down the side with 6 ribs on top. 1.7mm thick flat side with 2mm thick fluted section - 1mm thick in flute troughs. This item was used in the Edwardian and early vintage period. Supplied as 1.94 metre length and can be cut for despatch. Please note: the maximum length this can be sent on the standard courier service is 1100mm. Anything over will incur a large parcel fee.
Fluted angle, solid brass running board edging. Measures 18mm across by 18 mm down the side with 6 ribs on top. 1.7mm thick flat side with 2mm thick fluted section - 1mm thick in flute troughs. This item was used in the Edwardian and early vintage period. Supplied as 2 metre length and can be cut for despatch. Suitable for polishing or nickel plating. Please note: the maximum length this can be sent on the standard courier service is 1100mm. Anything over will incur a large parcel fee.
Polished aluminium with ribbed rubber step insert pad. 290mm wide x 235mm deep with 60mm upstand to rear. Sold individually.
Aluminium running board step plate with ribbed rubber insert. The aluminium frame is not polished or drilled. The moulded step plate insert is black ribbed. Dimensions approx 315mm long, ends 131mm and 104mm (front edge of step tapers) with 48mm high rear upstand which can be cut off if required. Offered in pairs only (1 left hand + 1 right hand).
Aluminium running board step plate with aluminium pyramid pattern tread insert. The aluminium frame is not polished. Dimensions approx 315mm long, ends 131mm and 104mm (front edge of step tapers) with 48mm high rear upstand which can be cut off if required. Offered in pairs only (1 left hand + 1 right hand).
Dickey seat step plate - an aluminium casting 130mm x 79mm with step tread top and curved under to fit on to the rear mudguard, to act as a step when climbing into rear dickey seat. Supplied undrilled etc only.
